Cooper Security i-dig02, Руководство по установке

Страница: 3 / 8

i-dig02
Page 3
and that SELV terminals are connected only to other circuits
designated as SELV circuits. Strict adherence to the installation
instructions will ensure that the equipment continues to comply
with the safety regulations to which it was approved.
1. SELV
terminals
2. TNV
terminals.
1
2
Figure 2. SELV and TNV Terminals
CAUTION: Make sure that the end station is not powered (either
mains or battery) before fitting the i-dig02.
Preparation
Before fitting the i-dig02 module, check whether the telephone line
you intend to use is shared with an ADSL (broadband) modem. If it
is, then remove the factory fitted jumpers from the i-dig02 and fit
filter ADSL01 as shown in Figure 3 .
ADSL01
Figure 3. Fitting ADSL01 to i-dig02