Cooper safety CEAG 1903 LED CG-S, Монтаж и эксплуатация, Страница: 11 / 12

CEAG Notlichtsysteme GmbH 11
Mounting and Operating Instructions
1903 LED CG-S
Introduce cables and connect the mains cable to the terminals
L and N of the module.
Set the addressing at the LED-supply-module.
Connect the LED-strip to terminals.
(Biipolar connection to LEDs - a polarity must not be observed -!)
Now pull the enclosure over the luminaire from below until the
snap hooks snap in.
7.3 Monitoring
For monitoring each luminaire must be addressed individually (s. table). If the luminaire shall
not be monitored address „0“ must be set at both adress switches.
8 Servicing
Observe the relevant national regulations which apply to the maintenance, servicing and
check of electrical apparatus. On condition of an appropriate operation and of observing
the mounting instructions and environmental conditions, no permanent servicing will be
required. For replacement of the lamp see chapter „Installation“.
9 Recycling
When a defective apparatus is disposed of, the respective national regulations on waste
disposal and recycling will have to be observed. Plastic parts have been provided with
respective symbols.