14
3.2.3 Install the indoor unit.
The installation of the indoor unit is shown in Fig. 3.4.
(1) How to fix the suspension bolts and the nuts
As shown in the figures 3.5, the nuts are fixed four
bolts.
Suspension bolts (4-M10 or W3/8)
( Field supplied )
Nuts and
washers (4-
M1 0 or W3/ 8)
( Field supplied )
Fig. 3.4 The installation of the indoor unit
(2) Install the indoor unit
·
As shown in the following figure, place the left hanger
bracket on the nuts and washers of the suspension
bolts.
·
Make sure that the left hanger bracket has been fixed
on the nuts and washers securely, install the right
hanger bracket suspension hook on the nuts and
washers.
(When installing the indoor unit, you can slightly
remove the suspension bolts.)
3.2.4 Adjusting of the unit level
(1) Check to ensure that the foundation is flat, taking
into account the maximum foundation gradient.
(2) The unit should be installed that the drainage side
is slightly (0mm~5mm) lower than other sides for
adequate drainage.
(3) After the adjustment, tighten the nuts and swear the
thread locker on the suspension to prevent the nuts
from loosening.
(1) During the installation, please cover the unit with the
plastic cloth to keep it clean.
(2) Make sure that the unit is installed level by using a
level or a plastic tube filled with water in instead of a
level, adjust the top surface of the unit to the surface
of the water at both ends of the plastic tube and adjust
the unit horizontally.(one thing to watch out for in
particular is if it is installed so that the slope is not in
the direction of the drain piping, as this might cause
leaking.)
CAUTION
Rack
Double nuts
and washers
Hanger bracket
Suspension
bolt
Indoor unit
Fig. 3.6
3.2.5 Installing the duct
•
Make sure the external static pressure of the unit is
within the range.
• Connect the duct and intake-side flange.
• Connect the duct and outlet-side flange.
• The connection of indoor unit and air duct must be well
sealed and kept warm with insulation material.
<Example>
CAUTION
Fig. 3.7
Canvas duct
Horizon
Service mouth
Air inlet
(with filter)
（
600mm-600mm
）
Air-outlet
The valve for the amount of air
Insulation material
Outside air
(through
the filter)
Static pressure
box
Canvas duct
Static pressure
box
The valve for
the amount of air
Nut
Indoor unit
Washer
Double nut
Fig. 3.5 Suspension bolts and nuts
Approx 50mm
5m
m
DC Inverter E
-
Series
Duct Type
Unit
