Page 8
Detergent and rinse aid
Detergent
Detergent specifically intended for use with
dishwashers must be used. The dispenser must be
filled before the start of each wash cycle following
the instructions provided in the "Wash Cycle Table".
The detergent dispenser is located on the inside
panel of the door.
Loading the detergent
To open the cover on the dispenser, press the latch.
The detergent for the wash cycle should be placed
in the compartment.
After the detergent has been placed in the
dispenser, close the cover and press down until it
"clicks" in place
Please Note: To facilitate closing the cover,
remove any excess detergent on the edges of
the dispenser.
Rinse aid
This product makes dishes sparkle and helps them
to dry without spotting. The dispenser is located on
the inside panel of the door and should be filled
after every eighty wash cycles (or when the "low
rinse aid" indicator light comes on for those models
with this feature).
Loading the rinse aid
Regardless of the type of detergent dispenser
installed on your appliance, you must proceed as
indicated below when loading the rinse aid.
To open the dispenser, release the cap in an anti-
clockwise direction and then pour in the rinse aid,
making sure not to overfill.
The amount of rinse aid used for each cycle can be
regulated by turning the dose adjuster, located
beneath the cap, with a screwdriver. There are 6
different settings; the normal dosage setting is 3.
Important:
Proper dosage of the rinse aid improves drying.
If drops of water remain on the dishes or
spotting occurs, turn the dosage adjuster to a
lower setting.
FIGURE 17
COVER
LATCH
CAP
DOSE
ADJUSTER
COMPARTMENT
