Page 5
Installation
- continued
Fitting your decorative fascia door
Provision is made on the dishwasher front panel for the
fitting of your own fascia door to match the rest of your
kitchen units. It is held in position by two clips at the
bottom and two screws at the top. A template is provided
to aid the positioning of the brackets and screws.
1. First check the width of your door is between 582mm
and 598mm.
2. Align the template with the top and the side of the door,
tape it in place and mark the position of the screw holes;
first one side and then the other (Figure 4).
3. Make pilot holes in the door and then, using the short
12mm self-tapping screws supplied, screw the two lower
brackets in position with the tabs pointing downwards
(Figure 5).
4. Locate the two lower tabs on the door brackets into the
slots in the dishwasher front panel. Lift the door up and
slide to the right (Figure 6).
5. Open the dishwasher panel right down and align the top
corners of the door with the top corners of the
dishwasher panel (Figure 7).
6. Attach the top of the door to the dishwasher front panel
with two of the self-tapping screws supplied and then fit
the two plugs onto the heads of the screws (Figure 7).
Fitting the dishwasher under the work
surface
1. Slide the dishwasher into the opening under the work
surface, just far enough to connect it to the water and
electric supplies and also the wastepipe (Figures 8
opposite and 2 and 3 on page 4).
Ensure the small filter is secure inside the hose
connector which connects to the water supply tap. Only
use the 90° connector to connect to the dishwasher.
2. Peel the backing paper off and stick the protective plastic
strip to the underside of the work surface.
FASCIA DOOR
FASCIA
DOOR
FASCIA
DOOR
FASCIA
DOOR
SLOT FOR
LOWER
BRACKET
LOWER BRACKETS
TEMPLATE
STICKY TAPE
BLANKING PLUG
APPLIANCE
INSERT SMALL
FILTER HERE
WATER
SUPPLY
PIPE
STRAIGHT
CONNECTOR
PROTECTIVE
PLASTIC
STRIPS
90
º
CONNECTOR
SELF-TAPPING
SCREW
SELF-TAPPING
SCREWS
FIGURE 4
FIGURE 5
FIGURE 6
FIGURE 9
FIGURE 8
FIGURE 7