Page 10
Starting the dishwasher
Starting a wash cycle
Turn on the electricity and water supply to the
dishwasher.
Partially open the door of the dishwasher, and press
the ON-OFF button "A" located on the control panel.
The "B" indicator light will come on.
At this point, the appliance is on and ready to be
programmed.
Setting and starting a wash cycle
Choose the desired cycle by pressing the cycle
selection button "P". Each time it is pressed, one of
the cycle indicator lights "D" will come on in
succession.
Choose the wash cycle you feel is most appropriate
for the type of dishes that need washing (consult
the wash cycle table (page 11), especially when first
using the appliance). Close the door and after a few
seconds, a short acoustic signal will sound
indicating that the wash cycle has begun and
cannot be modified, If necessary, read the
paragraph entitled, "Cancelling or modifying a cycle
while underway". The end of the cycle will be
signalled by a double acoustic sound, and the
indicator light "D" will begin to 'blink'.
Cancelling or modifying a cycle while
underway
Example: A cycle that is underway can only be
modified if it has only been running for a short time.
Otherwise, the detergent may have already been
used, and the appliance may have already drained
the wash water. If this is the case, the detergent
dispenser must be refilled (see the paragraph
entitled, "Loading the Detergent").
To change the cycle currently underway, open the
door, press the "P" cycle select button and hold it in
for about 5 seconds. Once the cycle has been
cancelled, the dishwasher will emit a short acoustic
sound and the respective indicator light will turn off.
To set a new wash cycle, follow the instructions
contained in the paragraph entitled, "Setting and
Starting a Wash Cycle".
If you forget to load some of the
dishes
The wash cycle can be interrupted by opening the
door carefully (in order to avoid being sprayed by
hot water). When the door is closed again, the cycle
will automatically restart at the point where it left off.
At the end of the wash cycle
The end of the cycle will be indicated by a double
acoustic signal and the 'blinking' of the "D" indicator
light. Open the door, turn off the appliance using the
ON/OFF switch and turn off the water supply to the
appliance. Wait a few minutes before removing the
dishes so as to avoid handling them while still hot
(when they are more susceptible to breakage) and
to get better drying results.
Front control panel
A
B
P
D
A. ON-OFF Button
B. ON-OFF Light
P.
Cycle Select Button
D. Cycle Indicator Lights
FIGURE 21
