WATER FILLING OF WATER TANK BODY
1.
Water should be filled to a position 20mm higher than the water line. If lower, heating may
not be realized. If higher, water may spill over the tank in use.
2.
Maintenance of water in the water tank body:
a
. Water in the water tank body should be filtered at fixed time regularly. It is not suggest-
ed to filter the water at all times.
b
. Water in the water tank body should be treated with chemical agents periodically.
However, chemical agents with calcium ions must not be used. If chemical agents with
calcium ions are used for water treatment, there will be very likely to form scales on the
walls of water tank and inner heating pipes.
c
. Water scales will directly damage the inner electrical components inside the control
cabinet and further affect the service life of control cabinet.
3.
If the filtration system has worked for 168 hours, the system will emit a warning tone to
remind the user to clean or replace the filter element.
CONSERVATION OF SPA
•
Drain off the water inside the water tank completely and wipe off droplets of water on the
walls.
•
Lay aside the SPA for 24 hours, exhaust the air and fold. If it is Winter, please fold the
SPA indoors.
•
Put the SPA inside the packing case after folding it well and then put the case in a shad-
ed place to avoid direct sunlight.
MAINTENANCE
Water Filter
1.
Clean your filter cartridge at least once after it worked continuously for 80-100 hours.
2.
The filter cartridge should be replaced at least once a month depending on use.
3.
Change water every few days or use appropriate pool chemicals. Please consult your
local pool supply retailer for more information about chemical maintenance.
4.
Water balance: we recommend you to maintain the water PH between 7.2 and 7.8, total
alkalinity between 80 and 120ppm and free chlorine between 3 to 5ppm. Low PH will
damage to the spa and pump.
5.
Water sanitation is achieved through both regular and periodic (daily, if necessary) addi-
tion of an approved sanitizer. The sanitizer will chemically control bacteria and viruses
present in the fill water or introduced during use of the spa.
Cleaning the filter cartridge
1.
Make sure to unplug the power pack from the electrical outlet before cleaning the filter
cartridge.
2.
Unscrew the filter cartridge by turning counterclockwise.
3.
Remove the filter cartridge cover.
Drainage
1.
Make sure to unplug the power pack from the electrical receptacle.
2.
Put the plastic plug into the outlet in the inner wall of the spa.
4.
The filter cartridge can be rinsed off with a garden hose and reused. However, if the filter
cartridge remains soiled and discolored the filter cartridge should be replaced.
5.
Put on the filter cartridge cover and place the filter cartridge to water inlet by turning it
clockwise, as shown on the next page.
2
4
3
5
3.
Open the outlet in the outer wall of the spa. Screw one end of inflation hose into it.
4.
Pull the plastic plug off from the outlet in the inner wall of the spa, then the water will flow
out.
5.
When there is no water in the spa, you must put on the jet function 2-3 minutes by press
the “Jet” button to drain the water in the air pipeline.
6.
When drainage is finished, remove the inflation hose and screw the nut tight.
Cleaning the spa
Detergent residues and dissolved solids from bathing suits and chemicals will gradually accu-
mulate in the spa’s water.
To clean the spa, use soap and water, and then rinse.
Note: do not use hard brushes or abrasive cleaners as this will damage the spa.
REPAIR AND STORAGE
•
Spa repair
If the spa is torn or punctured, use the provided repair patch. Dry the area affected by the
repair. Apply the glue in the accessory bag to the repair patch and then attach it onto the
damaged area. Smooth the surface to remove any air bubbles. A secure unnoticeable repair
can usually be made.
•
Spa storage
Make sure all water is drained from the spa and control box. This is essential to extend the life
of the spa. We recommend the use of a wet/dry vacuum to blow out or suck up water from the
spa pipes and pump lines. Remove the filter cartridge. It is recommended you store the spa
in its original package in a warm dry place. Note: Plastic becomes brittle and susceptible to
breakage when exposed to subzero temperatures. Freezing can severely damage the spa.
CORRECT DISPOSAL OF THIS PRODUCT
This marking indicates that this product should not be disposed with other
household wastes throughout the EU. To prevent possible harm to the environ-
ment or human health from uncontrolled waste disposal, recycle it responsibly
to promote the sustainable reuse of material resources. To return your used
device, please use the return and collection systems or contact the retailer
where the product was purchased. They can take this product for environmen-
tal safe recycling.
EN
Содержание ZENKURU PH050017
Страница 26: ......
