4
STARTING THE ENGINE
To be done only on the starting stand - Fig. 2. After opening the tank filling hole, fill
the lank with fuel and close it by screwing-in cap. Open the petrol supply cock by
turning the small lever into position "ON", Fig. 3. Set the choke lever into position
"C',Fig. 3. Without turning the accelerating handle, pull gently twice the starting
wire and by next quick pull start the engine. It is not allowed to pull the starting wire
up to full winding off. After a short engine run, put the choke lever back to position
"A" and let the engine run about 1 min. Let the Pocket bike on the larking stand and,
if need be, adjust the no-load speed to such a rate lest coupling should take along
the no-load speed to such a rate lest coupling should take along the rear wheel.
For adjustment use the adjustment screw N° 4 on the carburetor, Fig. 3.
Fig. 2
Fig. 3
CARBURETOR
OFF
1.
Suction chamber
2.
Sleeve screw
3.
Carburetor body
4.
Adjusting screw of no-load run
5.
Float chamber
6.
Fuel cock
RIDE
After mounting the Pocket bike and slow turning the acceleration handle, you
are starting your ride. Before braking, turn back the acceleration handle and
depress slightly the front brake lever and then the rear brake lever. Beware of the
wheels not to get them in skid.
The Pocket bike engine will be switched off by pushing the red push-button of the
stop switch on handlerods. After the first half-hour ride it is necessary to
check the tightening of screws and nuts, especially of the engine. Check also the
brake setting.
Содержание POCKET BIKE QG-40
Страница 1: ...WWW POWERDIRTBIKES COM USERMANUAL POCKETBIKEQG 40 ...
Страница 9: ...UFREE SPORTS VEHICLE www scooter manufacturer com ...
Страница 10: ...9 10 UFREES PORTS VEHICLE www scooter manufacturer com ...
Страница 12: ...13 C40 02 907 FRONT BRAKE COMPLETE C40 10 907 REAR DRAKE COMPLETE Fig 7 ...