OPERATION INSTRUCTIONS (continued)
E. ADJUSTING THE END LIMITS AFTER THE MOTOR HAS BEEN PROGRAMMED
a. To change the upper limit run the motor to its upper limit and let it stop. Press the
UP
and
DOWN
buttons simultaneously until the motor jogs. Run the motor to the new desired upper limit. Press and
hold the
MY/STOP
button until the motor jogs. Check the new limit.
b. To change the lower limit, run the motor to its lowe limit and let it stop. Press the
UP
and
DOWN
buttons simultaneously until the motor jogs. Run the motor to the new desired lower limit. Press and
hold the
MY/STOP
button until the motor jogs. Check the limit.
E. ADJUSTING THE END LIMITS AFTER THE MOTOR HAS BEEN PROGRAMMED
a.
To add or delete a remote/channel
, press the
PROGRAMMING
button on the back of an already
programmed remote/channel until the motor jogs. Next press the
PROGRAMMING
button on the
back of the remote/channel you wish to add or delete until the motor jogs
b.
To reset the motor to factory mode
, start with the motor connected to the power. Cut power for
8 seconds, reconnect power for 8 seconds, cur power for 8 seconds and then reconnect power. The
motor should start to run (if this does not happen, repeat the 8 second power cuts until the motor
does run). Allow the motor to stop on its own (do not press stop, up or down or you will have to repeat
the double power cut). Once the motor stops on its own, press and hold the
PROGRAMMING
button
for over 8 seconds. The motor should jog twice.
F. PERFORM A DUAL POWER CUT TO DELETE ALL PREVIOUS SETTINGS AND RETURN MOTOR TO
FACTORY MODE
a. Unplug the battery cable from the motor cable for 5 seconds.
b. Plug the battery back into the motor cable for 10 seconds.
c. Unplug the battery cable from the motor cable for 5 seconds.
NOTE:
When the shade stops, press and hold the
PROGRAMMING
button of any transmitter until the
window covering jogs twice. Do not release the
PROGRAMMING
button until the jogging is complete
or you will have to start the dual power cut form the beginning.
21
