Cool Nights Spas CN 10000, Руководство пользователя

Страница: 23 / 52

21
O p e r a t i n g I n s t r u c t i o n s
Setting the Water Temperature
Use the Warm/Cool [or Temp for the 4-button panel] buttons to set
the water temperature you desire. The temperature setting
displays for five seconds to confirm your new selection. The set
point icon indicates that the display shows the desired
temperature (not the actual water temperature). The default
temperature setting is 100ºF.
Setting the Filtration Cycles
To set the filtration cycle start time, reset the controller by power
cycling (power off). After the five minute priming, the filtration
cycle starts 12 hours later. You can also skip the priming period by
pressing the Warm/Cool [or Temp for the 4-button panel] buttons.
To change the filter cycle setting:
Filter duration is programmable for 2, 4, 6, 8 hours or for continuous
filtration. The default filter time is 2 hours. To program, press
Warm/Cool [or Temp for the 4-button panel] button, then Mode
[Jet]. Press Warm/Cool [Temp] buttons to adjust. Press Mode [Jet]
to exit.
When Jets 1 [or Jets for the 4-button panel] LED is ON and the Heat
LED is OFF, the spa is in filtration mode.
Covering Your Spa
Place the insulated cover on your spa. Keeping the cover in place
anytime the spa is not in use reduces the heating time and
minimizes operating costs. The time required for initial heat-up
varies depending on the starting water temperature, ambient
temperature and the capacity of your spa.
Water Chemistry
Once your spa reaches 90ºF or higher, add the start-up AquaClara
Natural spa care system (if equipped, see page 20) to the water.
Turn Pump 1 on high speed immediately after you add AquaClara
Natural to the water to evenly distribute AquaClara through your
system.