Convey HC-1EX Server Quick Start Guide v1.3
7
Desktop Usage
2.5
The Convey HC-1EX Server System is normally intended to be installed in a standard
equipment rack, however, it is understood that some applications will require the system
to be placed on a desktop. Please observe the following installation suggestions:
Consider a foam cushion beneath the server to reduce vibration and noise
coupling to the mounting surface
Consider placing the unit so that the air is exhausted away from any nearby users
The front mounting brackets are necessary to keep the top and bottom chassis
segments joined, and cannot be removed. If this is unacceptable, Convey offers
an alternate, flat bracket to reduce the size of the brackets.
Power
2.6
The Convey HC-1EX Server System consists has two power supplies, and consequently
two independent power cords. North American 115V cord sets are the default; however
the user is responsible for insuring that local codes are met by the power cords. The
power supplies may be run at 100-127/200-240 VAC 50-60 Hz, so confirm that the
default cords are appropriate to the application. Other options may be available from
Convey.
Because the power requirements are highly code-dependent, site preparation and peak
power allocations are hard to specify universally. For maximum headroom and flexibility,
Convey suggests a dedicated 15-amp 115 VAC service be allocated to each HC-1EX
Server System in a standalone installation.
Note that the two power cords do not provide redundant
2.7
power. As such, they should be connected to the same AC
power circuit.Power On
The Convey HC-1EX has a required power on sequence. If AC power is not switched to
both power cords, connect the lower chassis (host) power cord first, followed closely by
the upper chassis (coprocessor) power cord. After AC power is supplied, the host and
coprocessor management subsystems are initialized. The system status and System ID
LEDs on the Control Panel and rear of host chassis will blink during this initialization.
The system Power On button should be pressed only after the blue system ID LED stops
flashing. If the blue system ID LED does not flash after connecting the AC power cords,
wait a minimum of two minutes before powering on the system. Server fans will start up
during this time.
After turning on system power, the server runs through its Power-On Self Test, BIOS and
operating system boot messages are displayed on the VGA console. Note that there is a
delay of about 40 seconds between turning on server power and the first output to the
VGA console.
Installing Optional Hardware
2.8
To install any optional hardware not preconfigured in your system, see the Convey HC-
1EX Server System Service Guide.
