RECOMMANDATIONS DE MISE EN PLACE
RECOMMANDATIONS DE MISE EN PLACE
1
1
OVERHEAT CONTROL
MAINTENANCE
6
7
- This heater is equipped with separate overheat controls for the radiant panel and for the
fan-forced heat. In case of a malfunction of the unit (blocked air output or intake, for
example) the heater will stop heating automatically. After correcting the malfunction the
heater can be reset. To restart the heater :
- For the radiant heater, check that the top outlet grill (top back of the heater) is free of
obstruction, then push the reset button on the upper back panel of the heater.
- For the fan-forced heat : Turn the heater Off. Check that the lower back inlet and the
lower front outlet are free of obstruction. Wait 5 minutes and turn the heater back on.
If the light is still off, and no heat is generated, call your electrician or the nearest
CONVECTAIR
repair center.
- To keep your CONVECTAIR unit clean, regular maintenance is suggested. To
remove dust, use a soft cloth. To remove a stain, use a damp cloth. For a better
performance and maximum efficiency, it is suggested that dust and lint be regularly
removed from the protective grill situated at the back of your DIVA .
NEVER USE ABRASIVE OR ACETONE-BASED PRODUCTS TO CLEAN YOUR
HEATER AS THIS MAY DETERIORATE THE EPOXY FINISH.
ANY REPAIR ON YOUR CONVECTAIR HEATER SHOULD ONLY BE DONE BY A
QUALIFIED TECHNICIAN, AND ONLY AFTER THE HEATER HAS BEEN
DISCONNECTED.
Your
CONVECTAIR
heater will become hot when in use. Caution is advised when young children are
present.
Do not insert small objects in the heater : this could cause an electrical short circuit, fire or damage to the
inner components.
Any use or modifications not approved by CONVECTAIR may cause electrical short circuits, fire or injuries
to the users.
In certain cases, it is possible for yellowing of the surface to occur over time. This is not due to a
manufacturing defect. This is caused by surrounding air, which may contain smoke or dust, being heated
and circulated through the heater.
Prevention : it is suggested that surfaces be frequently cleaned especially with units installed in
locations where cigarette smoke is present or in the kitchen. Never use this heater during
construction work or other activities that generate a lot of dust.
Note : The first time your CONVECTAIR heater is used, a light smoke could be released. This is normal
and should disappear after about 2 to 3 minutes.
Operation and maintenance tips
9.
