TOWER HEATER - CTH08
|
3
OPERATION
Ensure the heater is plugged into a mains
power outlet and is switched on.
Turn the isolation switch on (I), at the back of
the heater, to begin use. The heater will make
a ‘beep’ and the power indicator on the display
panel will become lit.
The control panel or the remote control can
be used to operate the heater, except for ECO
mode, which is exclusively on the control
panel.
OPERATION
DISPLAY
Control Panel
Remote Control
ON/OFF Button
HEAT Button
TEMP set Button
TIMER Button
SWING Button
BODY sensor
Button
1h
14°
18°
22°
26°
2h
4h
8h
HEAT
Button
TIMER
Button
SWING
Button
ON/OFF
Button
TEMP
Button
BODY
sensor
Button
ECO
Button
1h
14°
18°
22°
26°
2h
4h
8h
ECO
Body
sensor
Temperature
setting
Timer
setting
High
Heat
Swing
Low
Heat
Power
Display Panel Indicators
OPERATION CONT.
Turning on/off
Press the ON/OFF button, on the heater or
remote, to turn the heater on. The heater will
start in the last operating mode used.
To turn the heater off press the ON/OFF
button.
Note! The fan will continue to run for a further
ten (10) seconds, after the heater is turned off.
Heat settings
The heat setting can be switched between
low heat (1700W) and high heat (2400W) by
pressing the HEAT button.
Swing function
The heater can be set to oscillate from side to
side to better distribute heat within the room.
Press the SWING button to turn swing mode
on & off. The swing indicator on the display
panel will be lit when swing mode is on.
Temperature control
The heater has an option to control the room
temperature to a set point. The temperature
can be set to 14°C, 18°, 22°C or 26°C.
When the room temperature exceeds the set
temperature the heater will turn off. When the
room temperature drops 2°C below the set
temperature the heater will resume heating.
Set the temperature control by pressing the
TEMP button. The indicators on the display
panel will show the temperature selected.
If no indicators are lit then temperature control
is not selected, and the heater will continuously
operate.
