GB
4
WOOD
COAL
Handle
(removable on modern)
FACTS
Building application
Before installing a stove or erecting a
chimney it is necessary for you to apply
for planning permission from your local
authority. Ask your local authority for
advice regarding building regulations and
the application.
Technical data
Output
3-5 kW
Nominal output 4 kW
Efficiency level Up to 80%
Model Classic
Weight (kg)
85
Width (mm)
479
Depth (mm)
408
Height (mm)
642
Model Modern
Weight (kg)
81
Width (mm)
492
Depth (mm)
368
Height (mm)
660
The connector’s inner diameter is Ø126 mm
Type approved in accordance with:
European standard EN-13240
DEFRA exempted
The stove can be used in
Smoke Control Areas.
Fire-box insulation panels
Grate
Ash-pan
Log guard
Type plate
Primary air
inlet control
Secondary air
inlet control
Chimney
Note!
The stove installation and connection
to a chimney must be accomplished with
the current edition of Building Regulations.
We recommend that you consult a local
chimney sweep before the installation
to make sure that the chimney is in good
condition.
The stove is type approved and must be
connected to a chimney dimensioned
for at least 350°C. The connector on
the appliance is suitable for pipes with
diameter of 125 mm. The stove can be
loaded with maximum 100 kg of chimney.
A flexible flue liner or steel flue
certified for use with solid fuel is highly
recommended. The stove requires a
draught in the chimney of at least –12
Pa. The draught is affected both by the
length and area of the chimney, and by how
well sealed it is. Minimum recommended
chimney length is 3.5 m and a suitable
cross section area is 120-175 cm² (125-
150 mm in diameter). Carefully check that
the chimney is sealed and that there is
no leakage around soot hatches and flue
connections.
Note that a flue with sharp bends and
horizontal routing reduces the draught in
the chimney. Maximum horizontal flue is 1
m, on the condition that the vertical flue
length is at least 5 m. It must be possible
to sweep the full length of the flue and the
soot hatches must be easily accessible.
General
In this manual you will find instructions
about how your Contura i4 FS shall be
installed. Before you start the installation
it is important that you read this
instruction carefully and fully understand
the requirements. All European, national
and local standards and regulations
needs to be fulfilled when the appliance is
installed.
To guarantee the function and safety of
the stove we recommend that it is installed
by a professional. Our Contura agents can
recommend a suitable installer.
The room or space containing a stove shall
have a permanent air supply sufficent to
ensure proper combustion, to determine
correct amount of air supply use current
edition of Building Regulations.
Remember to use only for the appliance
recommended fuel as wood logs
or smokeless fuel as anthracite or
manufactured smokeless fuel briquettes.
Do not ever burn bituminous coal, “petro-
coke” or other petroleum based fuels!