CONTROLS, INCORPORATED
C O N T R O L S Y S T E M S & S O L U T I O N S
- 14 -
Configuration Menus
(1)
Input Configuration
Analog 1 Function - Pre Set to Fuel Level S-W
Digital Input Function (NO/NC, Action, Message, When Active)
Digital B1 Function - Pre Set to Throttle Up
Digital B2 Function - Pre Set to Throttle Down
(2)
Throttle Configuration
Throttle Type Selection (Default = TSC Vernier)
TSC Mode Selection (Default = Primary)
TSC Min Speed Selection (Default = 650 RPM)
TSC Max Speed Selection (Default = 2400 RPM)
TSC Ramp Rate Selection (Default = 100 RPM/Sec)
Throttle Curve Selection (Default = Linear)
Multistate Speed 1 Selection (Default = 650 RPM)
Multistate Speed 2 Selection (Default = 650 RPM)
Multistate Speed 3 Selection (Default = 650 RPM)
Multistate Speed 4 Selection (Default = 650 RPM)
(3)
Module Configuration
Pressure & Temperature Units (Default = English)
Hour Meter Source (Default = Engine ECU)
Hour Meter (Default = 0 Hrs)
Display Battery Source (Default = J1939)
Battery Volt Trim (Default = 5 100mV)
(4)
CAN Configuration
Source Address (Default = 44)
TSC1 Address (Default = 3)
Engine Address (Default = 0)
Oil/Fuel Transmit On/Off (Default = Off)
(5)
Emissions Configuration
DEF Level Check (Default = Off)
Low DEF Pre Alarm (Default = 16%)
TSC Regeneration Speed Selection (Default = 750 RPM)
Allow Service Regeneration Yes/No (Deere Only)
Regeneration Interlock On/Off
TSC Transmit Yes/No (stop TSC to engine during regeneration)
(6)
MOD bus Configuration
Baud Rate (Default = 38400)
Parity (Default = None)
Stop Bits (Default = 1)
Slave Address (Default = 1)
Enable Gauges Yes/No (Default = Yes)
Tachometer Range (Default = 0-3000 RPM)
Engine Oil Temperature Range (Default = 100-250
F)
Transmission Oil Temperature Range (Default = 100-250
F)
