CONTROLS, INCORPORATED
C O N T R O L S Y S T E M S & S O L U T I O N S
- 18 -
CONFIGURATION MENUS
(1)
Input Configuration
Analog 1 Function (Fuel Level Settings)
Digital Input 1 Setup (Pre-Set to Hydro-Throttle)
Digital Input 2 Setup (Pre-Set to Override Active)
Digital Input 3 Setup (Pre Set to E-Stop)
Digital Input 4 Setup (Pre Set to Low Water)
Digital Input 5 Setup (NO/NC, Action, Message, When Active, Delay)
Digital Input 6 Setup (NO/NC, Action, Message, When Active, Delay)
Digital Input 7 Setup (NO/NC, Action, Message, When Active, Delay)
Digital Input 8 Setup (NO/NC, Action, Message, When Active, Delay)
Digital Input 9 Setup (NO/NC, Action, Message, When Active, Delay)
(2)
Output Configuration
Relay Output 1 Setup (Function, Polarity, Initial State)
Relay Output 2 Setup Pre-Set to Fuel/Run
Relay Output 3 Setup (Function, Polarity, Initial State)
Relay Output 4 Setup (Function, Polarity, Initial State)
Relay Output 5 Setup (Function, Polarity, Initial State)
Relay Output 6 Setup (Function, Polarity, Initial State)
Relay Output 6 Setup (Function, Polarity, Initial State)
Relay Output 7 Setup (Function, Polarity, Initial State)
Relay Output 8 Setup (Function, Polarity, Initial State)
(3)
Throttle Configuration
Throttle Type - Throttle Type Selection (Default = TSC Vernier)
TSC Mode Selection (Default = Primary)
TSC Min Speed Selection (Default = 850 RPM)
TSC Max Speed Selection (Default = 2400 RPM)
TSC Bump Speed (Default = 20 rpm)
TSC Ramp Rate Selection (Default = 100 rpm/sec)
Throttle Curve Selection (Default = Linear)
Multistate Speed 1 Selection
Multistate Speed 2 Selection
Multistate Speed 3 Selection
Multistate Speed 4 Selection
