WebRelay Users Manual
ping -s 102 10.10.10.40
4.
Proceed with the WebRelay setup in
Section 3
.
Once setup is complete, it may be necessary to clear the 'arp' cache to configure additional devices.
This is necessary because each unit has the same default IP address, but a different unit serial
number (MAC address). Clearing the arp table can be done by typing
sudo arp -d -a
in the
command prompt window.
Mac OS X Instructions
1.
Open a terminal.
Note: The terminal is in the “Utilities” directory, which is in the “Applications” directory.
2.
Type:
sudo arp -s {new IP address} {serial number of the WebRelay }
Administrator password may be required.
Note: IP address format is xxx.xxx.xxx.xxx. The serial number can be found on the label on the
module board. The format is ss:ss:ss:ss:ss:ss.
For example, to set the WebRelay (with serial number 00-0C-C8-01-00-01 ) to 10.10.10.40 the
following command would be used:
sudo arp -s 10.10.10.40 00:0c:c8:01:00:01
3.
Next, type:
ping -s 102 {new IP address}
For example, if the new IP address is 10.10.10.40, the following command would be used:
ping -s 102 10.10.10.40
4.
Proceed with the WebRelay setup in
Section 3
.
Once setup is complete, it may be necessary to clear the 'arp' cache to configure additional devices. This
is necessary because each unit has the same default IP address, but a different unit serial number (MAC
address). Clearing the arp table can be done by typing
sudo arp -d -a
in the command prompt
window.
2.3.3 Open Configuration Web Page
Once the network is set up, open the setup pages by typing the following URL into the browser:
http://192.168.1.2/setup.html
Note: If option 1 above was used for initial configuration, replace the IP address given here with the
newly assigned IP address.
Xytronix Research & Design, Inc.
Page 33
