5
8 To install the charging station permanently into a table
or countertop
, remove the small rubber discs covering the
threaded holes in the base.
9
Install the threaded posts (all thread) into the base of the
charging station.
10
Using the template and a 1/4" drill, drill two holes into the
surface where you are mounting the touchscreen. Maximum
surface thickness is 32 mm (1.25").
11
Mount the charging station assembly into the mounting
holes and secure it in place using a washer and nut.
Troubleshooting
To power cycle the touchscreen:
1
Press and hold the (power) button for several seconds
until the touchscreen turns off.
2
Press and release the (power) button again to turn on.
To perform a factory data reset:
1
On the touchscreen’s main screen, tap
Settings
,
System Info
,
then
Factory data reset
.
- OR -
If the touchscreen has not yet been configured, tap
About
,
then
Factory data reset
.
- OR -
To reset without using the display screen:
a
Dock the touchscreen onto its charging station.
b
Press and hold the volume up button while using a
straightened paper clip to press and release the reset
button.
Reset hole
c
Keep holding down the volume up button until the icon
below appears on the screen, then release the button.
d
A message appears, indicating that data is being erased.
