Contrec 414Q, Руководство пользователя

Страница: 36 / 60

5.1 PROGRAMMING THE SETUP PARAMETERS
Step Display Description Text
Ref
1
CAL
BATCH
OPTION
TEST
END
Select the Calibrate mode to setup program
parameters.
Select Batch to enter Batch Setup parameters.
Option (if installed).
Select the test mode to check input signals.
Exit to normal operation.
5.2
5.3
5.4
The following steps are displayed if CAL is selected.
2
RESTOT
Reset all totals to zero.
To reset all totals (resettable and accumulated)
press the BATCH SET key once.
3
FL INP
Select either a single frequency input or a
quadrature input (ie two pulses from a single
flowmeter).
3.3
single
quad
Single Input.
Quadrature Input.
4
CORRCT
Linear
Nonlin
Select either a linear input or non-linear
correction for the flowmeter input.
Linear Correction, or
Non-Linear Correction.
3.6
5
SCALE
If linear correction is selected, the scaling factor is programmed as
follows.
Fact
Enter the Scaling factor (K-factor) of the
flowmeter. The program then steps to step 6. 3.4.1
34 Calibration