Contractor 10405, Руководство пользователя

Страница: 11 / 72

11
ENGLISH
CONTRACOR
®
DBS-RCS Art. 10405/10410
6. To remove the intake valve and the piston for inspection (pos.5 и 7) you should hold
the intake valve using the steel pin 5mm through the hole 1 1/4 ” from the side of
connection of the control valve with the machine. The pin is inserted in the hole in the
center of the intake valve. Loosen the screws (pos.16) and remove the piston and the
intake valve.
5.3. Assembling of RCV.
Assemble remote control valve RCV following the steps in section 5.2 in reverse order.
ATTENTION!
NEVER USE ANY WORN PARTS DURING ASSEMBLING.
THEY CAN DAMAGE THE CONTROL VALVE.
It is recommended to replace timely the parts marked with an asterisk (*) in the part
list, to avoid an excessive wear and damage of the control valve.
5.4. Daily maintenance.
1. Check the control valve for water presence. If water is present, check the CAF-3 filter
state.
2. Ensure that the rubber insert of the RC handle is in proper condition. If they look bad
or are worn, replace them, to avoid possible damage.
3. Ensure that hoses and fittings are not worn; and properly fixed.
5.5. Monthly maintenance
(or after every 160 operation hours).
1. Ensure that the muffler and its pipe are in proper condition.
2. Ensure that there is no leak in all air connections.
3. Dismantle the control valve following the steps in section 5.2 and check all moving
parts. If they look worn, replace them, to avoid possible damage. Assemble the valve
and lubricate its moving parts with general purpose lube oil.