22
W415-0857 / B / 02.14.11
C.
Depending on the type of installation, the
view of the log positioning will reverse. Here
the lower end of log #2 rests near the back
left corner of the fi rebox on the locating pin.
The upper end sits on top of log #1, inside
the groove on log #2.
D.
Log # 3 is made up of two pieces, a and b.
Piece #3a is the base of log #3. The base
sits diagonally in the designated area located
between logs #1 and fi ts tight up against #2.
E.
When pieces #3a and #3b are attached
to create log #3, the upper end of log #3
should rest in the groove, on top of log # 2.
The slot in the underside of piece #3b fi ts
over #3a. Place the end of piece #3b onto
the pin.
F.
As with log # 1, log #4 is also cradled by the
texture of the burner cover and the pin in the
base. Position log #4 so that the lower end
fi ts onto the pin. The upper end rests against
the moulded locator on the top of log # 1.
B.
Place log #1 diagonally across the textured
burner cover onto the pins. The texture is
designed to cradle the underside of the log.
LOCATING
STUDS
LOCATING SCREWS
A.
Looking at the unit from the valve side, place
the fi bre burner onto the locating studs on the
pan burner as illustrated above. It is important
not to cover any burner ports with the fi bre
burner.
