Continental Fireplaces CHDX40NT, Инструкция по установке и эксплуатации

Страница: 36 / 52

36
W415-0889 / A / 08.11.10
VARIABLE
SPEED
KNOB
SPEED
CONTROL
SWITCH
THERMAL
DISC
7.2 INSTALLING THE BLOWER
7.2.1
Open the blower kit and remove the thermal disc from the bracket. Remove the speed control bracket
from the burner base assembly, install the thermal disc and speed control switch onto the speed
control bracket
and reattach to the burner base.
7.2.2
Reverse procedure to re-assemble.
INSTALLATION TO BE DONE BY A QUALIFIED INSTALLER
and must
be electrically connected and grounded in accordance with local codes.
In the absence of local codes, use the current CSA C22.1 Canadian
electrical code in Canada or the ANSI / NFPA 70 national electrical code
in the United States.
Drywall dust will penetrate into the blower bearings, causing
irreparable damage. Care must be taken to prevent drywall dust from
coming into contact with the blower or its compartment. Any damage
resulting from this condition is not covered by the warranty policy.
To safely install the fan, turn off the electricity first.
Slide the vibration reducing pad
(A)
into the clip
(C)
and up against the threaded
stud
(B)
at the other end. The blower must be able to be positioned entirely onto
the pad.
Attach the connectors from the black and white
wires to the thermal disc.
Attach the connectors from the black and red
wires to the blower.
Plug the harness cord into the receptacle.
Because the blower is thermally activated, when turned on, it will automatically start approximately 10 minutes
after lighting the fireplace and will run for approximately 30-45 minutes after the fireplace has been turned off.
Use of the fan increases the output of heat.
black
white
red
VARIABLE
SPEED
SWITCH
BLOWER
THERMAL
SWITCH
A
B
C
51.2
GASKET
SPEED CONTROL
BRACKET
BLOWER