EN
W415-1430 / C / 06.05.19
25
installation
3.2.3 installing natural vent
ADAPTER INSTALLATION:
•
Remove the spill switch bracket from the rear of the
adapter.
•
Gently pull the two wire terminals (located inside the
7" (178mm) fl ue collar at the top of the appliance) out
approximately 8" (203mm).
•
Bring the wires through the lower hole in the adapter and
out the spill switch opening. To pass the wires through
the hole more easily, temporarily take the two terminals
together.
•
With the spill switch opening aligned to the back of the
appliance, take hold of the adaptor base and push the
crimped edge into the appliance fl ue collar.
•
Connect the wire terminals to the spill switch and re secure
the bracket.
For aesthetics, the adaptor has been designed to accept a
standard matte black 7" (178mm) appliance pipe and a decorative black band (standard with the GS150KT). Both
are available from your local authorized dealer / distributor.
SWITCH
SPILL
ADAPTER
Refer to "door opening and closing" section prior to proceeding
to prevent damaging the appliance.
A.
Remove both burners and the log support bracket.
B.
Remove the combustion air cover plate and its gasket.
THE TWO SCREWS MUST BE RE-SECURED.
C.
Undo the bracket holding the thermodisc, turn 90° as
shown and reattach to the weld stud located on the
right air manifold side.
NOTE: Do not tighten the wing nut until burner
is installed; then ensure that the thermodisc
fi rmly touches the underside of the burner tray
and tighten. This enables the blower to function
properly.
D.
Secure the terminal block into place as shown with the
screw supplied.
E.
Gently pull the two white spill switch wires to take
up any slack. Feed these wires down through the
combustion air opening and back up through the 4x6
inch cut-out in the base. Connect the shorter of the 2
wires to the terminal block.
F.
Disconnect the black on/off switch wire from the
terminal #1 (TH) of the gas valve and attach it to the
3/16" tab to the other side of the terminal block.
Connect the remaining wires (1 black - 1 white) with
1/4" connectors to TP/TH (3) and TH (1) on the gas
valve.
G.
Replace and re-secure the log support bracket and
the two burners ensuring that each venturi fi ts over the
burner orifi ce.
3.2.4 natural vent adaptations
TURBO
VIEWING
COMBUSTION AIR
COVER PLATE
MIRROR
REAR BURNER
FRONT BURNER
LOG SUPPORT BRACKETS