W415-4051 / C / 06.29.22
EN
47
finishing
7. Place log #6 onto the pin located on the right side corner of the burner,
then place one pin into middle of the log #6 and log #5
(Fig. 6).
8. Place log #7 onto the pin located in log #6 and onto the pin in log #5
(Fig. 7).
9. Place log #8 on the log support and let it rest against the notch in the
side of log #7
(Fig. 8).
HINT: The best view of log #8 is shown in the left side view
below.
10. Place log #9 onto the pin located in log #6 and let it rest on the right
side corner log support and then place one pin into log #7
(Fig. 9).
11. Place log #10 onto the pin located in log #7 and let it rest in the middle
of the right side log support
(Fig. 10).
Place one pin into log #1
(Fig.
10).
12. Place log #11 onto the pin located in log #1 and let it rest on the right
end log support
(Fig. 11).
13. Place charcoal lump #12 onto the two pins located in the center of the
burner
(Fig. 12).
14. Install the glowing embers, see "glowing embers" section.
15. Sprinkle the charcoal embers around the log support, see "charcoal
embers" section. (Use illustration below as reference).
16. Place the charcoal lumps on top of the charcoal embers, see "charcoal
lumps" section. (Use illustration below as reference).
RIGHT SIDE VIEW
1
11
2
3
10
6
9
7
4
12
Fig. 7
Fig. 11
Fig. 12
Fig. 8
PIN
Fig. 9
PIN
Fig. 10
PIN
LEFT SIDE VIEW
10
6
8
5
2
3
4
1
7
11
Ensure log #6 does not cover any burner ports.
note:
Fig. 6
PIN
PIN
Do not cover the pilot or burner ports with media or embers. Do not overfill.
note:
