IPSPOTQC
- 7 and 15x5W quadricolor LEDs waterproof projectors
Page 15
English
8 - Infrared remote control
The infrared remote control supplied with the projectors allows you to remotely control all their functions. The infrared
sensor is located at the front, between the LEDs.
Note : The remote control can even be used when the projector is in DMX mode.
The display always indicate the status of your projector.
1 - Black-out button
: Turns the projectors ON or OFF.
2 - SELECT PROG button
: Allows you to launch the built-in programs or to select the fixed colours. 4 different modes
are available, each pressure switches from one mode to another.
Please keep in mind : The colours and programs available with SELECT PROG depends on the DMX mode: pure
RGB or RGBW. The colours and programs differ from one mode to the other. Please refer to pages 6 to 14 for
more details about choosing a DMX mode.
Choose a DMX mode before using the SELECT PROG button.
1
st
pressure
Red LEDs flashing
: Fixed colours, step programs and crossfades selection with the 1 to 9 buttons, and
with the + and - buttons.
Strobe speed settings with the Flash button then with the + and - buttons.
Programs speed settings with the SPEED button and the + and - buttons.
2
nd
pressure
Blue LEDs flashing
: Automatic mode.
Strobe speed settings with the Flash button then with the + and - buttons.
Programs speed settings with the SPEED button and the + and - buttons.
3 - FLASH button
: Activates or deactivates the Flash mode. Increase or decrease the flash speed with the - and +
remote control buttons.
4 - SPEED button
: Allows you to configure the Step and Crossfade programs speed. Increase or decrease their
speed with the - and + remote control buttons.
6 - DMX mode selection - DMX MODE button
There is 13 DMX modes.
Before controlling your projector with a DMX controller, you will need to select a DMX mode;
To do so, press the DMX MODE button then use the + and - to switch from one mode to another :
LEDs on
Mode
LEDs on
Mode
Red
1CH2
Green and Blue
2CH5
Green
1CH3
Green and White
2CH6
Blue
1CH4
Blue and White
2CH7
White
1CH5
Red, Green and Blue
3CH5
Red and Green
1CH6
Red, Green and White
3CH6
Red and Blue
2CH2
Red, Blue and White
3CH7
Red and White
2CH4
7 - SET ADDR buttons and 0, 1, 2, 3, 4, 5, 6, 7, 8 and 9
: Allows you to configure your projectors DMX address.
For instance, if you want to configure the address 245 :
- Press SET ADDR, all the LEDs are flashing to indicate the process beginning.
- Press 2, the green LEDs of your projectors lit up to indicate the hundreds digit has been saved.
- Press 4, the blue LEDs of your projector lit up to indicate the tenths digit has been saved.
- Then press 5. All the LEDs will flash to confirm you the address has been saved properly.
Note
: For values with 1 or 2 digits, you will need to write down the 0. This means for the address 5, you need to
enter 0,0 and 5.
8 - R,G,B and W buttons
: Adjust the colours brightness, R for Red, G for Green, B for blue, W for white. Increase or
decrease the brightness with the + and - remote control buttons.
The A (amber) button is not used with these projectors.
