Contec FX-DS540-APDL-U, Руководство пользователя

Страница: 57 / 91

5. Setup and Status Display
50
FX-DS540-APDL-U
Basis
Interface
Disabling “Interface” disables the internal wireless LAN module.
Factory default setting : Enabled
Wireless LAN standard
Sets the wireless LAN standard to use. When the unit type is “Access point”, you can select one of
checkboxes. When the unit type is “Station”, you can select more than one check boxes according to the
standard of the access point to be connected. The wireless LAN standard to be used is determined
automatically depending on the destination access point.
Factory default setting : Check only IEEE802.11a.
Wireless Link Mode
Select the operation mode of the FX-DS540-AP/APP from among “Standard Infrastructure”, “Compatible
Infrastructure”, and “Advanced Infrastructure”.
Factory default setting : Standard Infrastructure
Table 5.2. Wireless Link Mode
Standard
Infrastructure Each access point can accommodate stations (such as wireless LAN cards) to make
up a network. This mode provides scalability from a middle- or large-scale system
with multiple access points connected by LAN to a small-scale system based on a
single access point.
Compatible
Infrastructure This mode allows the AP to be networked with other manufacturers' Wi-Fi certified
wireless terminals other than the FLEXLAN series. Note, however, that functions
such as IP tunneling cannot be used in this mode.
Advanced
Infrastructure The access point can be used in both of the Standard Infrastructure and Compatible
Infrastructure modes. This mode is a mixture of the two.
Unit type
Select either “Access point” or “Station”. “Access Point” means the Access point manages user units
and other Access Points that are operating as stations. “Station” means the Access Point is managed by
(logs in to) another Access Point and is set when the Access Point is used as a bridge or similar.
Factory default setting : Access point