Contec FX-DS540-APDL-U, Руководство пользователя

Страница: 31 / 91

3. Setup
24
FX-DS540-APDL-U
LED indicator
Three LEDs indicate the user unit connection, transmission/reception, power supply, and wired LAN
connection status.
Table 3.1. LED Display during Normal Operation
Name State Indicator
On
Indicates that the device is operating.
POWER
Flashing
Indicates that the device is being started (going to operate after the power
switch was turned on).
On Indicates that a wired LAN has been connected.
Flashing
Indicates the sending / receiving state between the terminal and data
connected by the wired LAN.
LAN
Off Indicates that a wired LAN has been unconnected.
On
Indicates that a user unit has been logged in (With access point).
Indicates that a user unit has not been logged in access point (With station).
Off
Indicates that a user unit has not been logged in (With access point).
Indicates that a user unit has not been logged in access point (With station). WLAN
Flashing Indicates that a user unit has not been logged in.
DIP switches
The DIP switches are used to initialize the AP and select the IP-less mode.
Table 3.2. DIP Switches
ON OFF Indicator
1 INIT -
Used to initialize the AP.
Turning on this switch makes the LED of POWER,
LAN, WLAN blink.
Turning this DIP switch off before (about 3 seconds)
staying illuminated from being blinking resets all the
AP’s settings to their factory defaults the next time
the AP is started.
2 IP LESS -
Turning this switch on, operating can be done without
setting the IP address on the AP
In this time, you cannot use the setup by WWW
browser or SNMP agent function.