ECG1200G Electrocardiograph - User Manual
20
among 3 leads ,6 leads, and 12 leads.
Lead-off information: In Demo mode, it displays "DEMO ECG", while in sampling mode, it
displays lead-off information detected.
Switch printing mode: when data mode is After Print, with the button
on the
keyboard, you can change the printing mode among manual, auto 12*1, auto 6*2+1, auto 6*2,
auto 3*4+2, rhythm 12, rhythm 10, rhythm 8, rhythm 6.
Adjust gain (Sensitivity): With the gain adjusting button
on the keyboard, you can
switch among 2.5mm/mV , 5mm/mV , 10mm/mV , 20mm/mV, 40mm/mV .
Adjust paper speed:With the key of speed adjusting button
on the keyboard ,you can
adjust paper speed among 5mm/s,6.25mm/s,10mm/s, 12.5mm/s, 25mm/s, 50mm/s.
Switch filter:With the key of filter selection button
on the keyboard ,you can switch
filter among no filter, AC, EMG, DFT, AC+EMG, AC+DFT, EMG+DFT, AC+EMG+DFT.
AC: AC Filter
EMG: EMG Filter
DFT: Baseline Filter
Print/Finish Printing: With the printing button
on the keyboard, you can begin or
finish the printing operation.
Auto Mode: After starting printing, automatically the system prints and stores synchronous 12
leads waveforms, of which the length is according to related setup in printing settings, and also
according to this to print analysis data and conclusion, then finish printing automatically.
Manual Mode: After starting printing, the user can print different lead instant waveforms by
switching the lead displayed, namely the ECG printed in manual mode is not synchronous and
the data will not be saved. You need to stop printing by pressing
again.
During printing process, the printing state and display content mainly include:
Display content
Explanation
Process…
It is printing.
Waiting…
It is finishing printing.
No Paper.
Paper lack, the user should restart printing after loading paper.
Print Timeout
Communication failure between this system and printing sub-system.
ECGTimeout
Communication failure between this system and sampling sub-system.
Low Power
Low power, it cannot start printing
13.3 Case Information Inputting
