—
Installation
—
CPS-MC341-A1-111 Reference Manual (Hardware)
—
37
—
2.
Connecting to an External Device
Use the supplied connector plug to connect the product to an external device.
The following example describes how to make the connecting cable with a 3-pin connector.
Applicable wire : AWG24 - 16
1
Strip off approximately 7mm (plus or minus 0.5mm) of the covered part of a cable and insert it
to the opening.
2
After the insertion, secure the stripped part by turning screws with a slotted driver to prevent it
from disconnecting.
CAUTION
Removing the connector plug by grasping the cable can break the wire. Always grasp the
connector to remove it.
Tightening torque of the supplied connector is described below.
DEGSON : 0.19 N·m, PHOENIX CONTACT, PTR MESSTECHNIK : 0.25 N·m
Strip off approximately 7mm (plus or minus 0.5mm) of the covered part of a cable to connect
with the connector.
Connection Cable
The supplied
connector
Power Supply
approx. 7mm
