Contec CONPROSYS Alpha Series, Справочное руководство

Страница: 91 / 121

—
Installation
—
CPSA-PCB100 Reference Manual
— 91 —
Unlock the hook with a slotted screwdriver
There are two ways to unlock the hook using a slotted screwdriver.
Unlock it by one of the following methods.

Using the screwdriver as leverage
Insert a slotted screwdriver (the point should be smaller than 4.5mm) into a hole.
(see the figure below)
By using the screwdriver as leverage, move it upward in the direction of the arrow to unlock.

By rotating the screwdriver
Place the slotted screwdriver (the point should be smaller than 8mm) as shown in the figure.
Rotate the screwdriver 90-degree in either direction.
2
(1). With the hooks unlocked, pull the lower part of the product toward you.
(2). By lifting the product, you can easily remove it from the DIN rail.
A projection tip to support the driver