
Introduction
Getting Ready
Taking Pictures
Playback
Set Up
EN-28
NEXT
BACK
Contents
Glossary
Index
Nomenclature
Menus and Settings
Troubleshooting
Inserting the Memory Card
1
Check that the camera is switched off
and then release the card/battery cover
latch.
q
Use the pad of your finger to slide the card/battery cover in the
direction of the arrow until there is a click and the latch is released
(approximately 1 mm).
w
The bottom part of the card/battery cover opens (approximately
10 mm).
2
Open the card/battery cover.
e
Pull out the card/battery cover until it is stopped by the hinge.
r
Fully open the card/battery cover.
3
Insert the memory card.
Insert the memory card with the labeled side facing the lens side of the
camera.
When inserting the card, push it into the slot until it makes a clicking
sound and stops.
4
Close the card/battery cover.
Push the card/battery cover into the opening in the camera surface
while you close it, then slide it in the direction of the arrow until it clicks
and locks.
Make sure the hinge does not lift up as you close the cover.
A
Important
• If the card does not slide in smoothly, the card may be upside down. Check that the
card is the right way up and do not try to force it into the slot.
• Do not attach stickers of any sort to the memory card as this may jam the card in
the slot so that you cannot remove it.
B
Note
Format the memory card in the camera before shooting to ensure the best possible
performance from the camera. (
Æ
p.161)
2
1
4
3
Hinge
Memory
Card Slot
Labeled
Surface
Cutout
Section
Push against
the upper
surface.