6
down based on the glass barrier’s thickness.
11. Put three of the 8-32 2” screws into the remaining holes in the plate,
screwing in enough to hold all pieces together.
12. Remove the alignment studs and replace with the remaining three 8-32 2”
screws.
13. Tighten the screws in a “star” configuration, tightening each screw in
small increments until all screws are completely tightened.
14. Secure the tubing in place.
15. Plug the wire’s connector into the “Cust Mic” port on the back of the
amplifier.
Note
: The RED wire should be on the RIGHT side of the
connector.
