Constructor CTSC90-406VS, Оригинальное руководство пользователя

Страница: 51 / 60

Inside Cuts
Warning: Switch off the saw
and remove the mains supply
plug before doing inside cuts
in order to avoid injuries
caused by unintentional
activation of the saw.
This saw is suited also to inside cuts
cut not starting at the edge of the work
piece. Proceed as follows:
• Drill a 6 mm hole in the work piece.
• Loosen the clamping screw (blade
tensioner) and release the tension in the
blade.
• Place the bore hole over the saw
blade slot
in the work bench.
• Install the saw blade through the hole
in the work piece and through the work
blade slot, and fasten the blade to the
holders.
• When you have completed the
inside cut, remove the saw blade and
then remove the work piece from the
bench.
Continuous Operation
It is possible to switch the saw on by
pressing the green "I" button for
continuous operation.
In order to switch the saw off, it is
necessary to press the red "0" button.
With the continuously variable electronic
speed control, the cutting speed can be
increased by turning to the right or
reduced by turning to the left.
Lighting System
(Not available on CTSC90-406VS)
The lighting system can be switched on by
pressing the red "0" button.
Flexible shaft
(Not available on CTSC90-406VS)
• Remove protective cap from the threaded
bushing.
• Place flexible shaft onto the
threaded bushing.
• Clamp tool in the drill chuck .
• Firmly hold threaded shaft at the
handle and switch on the speed
control.
• Having finished the work, remove
the flexible shaft and place the
protective cap in place.