CONSTRUCTA 9000472467, Инструкция по эксплуатации

Страница: 48 / 52

48
Removing the appliance door
1.
Open the appliance door fully.
2.
Open the locking levers on the left and right-hand side fully.
The hinges are secured and cannot snap closed.
3.
Close the appliance door until resistance becomes
noticeable (figure A).
4.
With both hands, grip the door on the left and right-hand side,
close the door a little more and pull it out (figure B).
Fitting the appliance door
1.
Insert the hinges in the left and right-hand holders (figure C).
The notch on both hinges must engage.
2.
Open the appliance door fully.
3.
Close the locking levers on the left and right-hand side fully
(figure D).
The appliance door is secured and can no longer be
removed.
4.
Close the appliance door.
Cleaning the door panels
To assist with cleaning, the inner door panel can be removed
from the appliance door.
m
Risk of injury!
The components inside the appliance door may have sharp
edges. Take care not to cut yourself. Wear protective gloves.
m
Risk of injury!
The appliance must not be used again until the door panels
and appliance door have been correctly fitted.
Removing the door panel
Note:
Before removing, make a note of the orientation in which
the door panel is fitted, so that it is not refitted the wrong way
round.
1.
Unhook the appliance door and lay it on a soft, clean surface
with the front side facing downwards (see section: Removing
and installing the appliance door).
2.
Unscrew the cover at the top left and right of the appliance
door and detach it (figure A).
3.
Lift the door panel and remove it (figure B).
Cleaning
Clean the door panel with glass cleaner and a soft cloth.
Caution!
Do not use any sharp or abrasive medium or a glass scraper.
The glass could be damaged.
Fitting the door panel
1.
Slide in the door panel all the way.
2.
Put the cover back in place and screw it in.
3.
Refit the appliance door.
Cleaning the hook-in racks
You can remove the hook-in racks for easier cleaning.
m
Risk of burning due to hot components in the cooking
compartment!
Wait until the cooking compartment has cooled down.
1.
Push the hook-in rack upwards at the front and unhook to the
side (figure A).
2.
Pull the hook-in rack forwards at the rear and unhook to the
side (figure B).
3.
Clean the hook-in rack with washing-up liquid and a sponge
or brush.
4.
Align the hook-in rack with the indentation (a) facing
downwards, so that the shelf heights match.
5.
Insert the hook-in rack at the rear as far as it will go and push
to the rear (figure C).
6.
Insert the hook-in rack at the front as far as it will go and
push downwards (figure D).
A B
C D
A B
A B
a
a
C D