Notch
14 13 12 11 10 9 8
Step 3b: Continuing to the other side of the chip.
pins 8-14:
•
Pin 8:
This is the long white wire for the Player 3 LED and
should be 2.25 inches long
•
Pin 9:
This is the medium length white wire for the Player 4
LED and should be 2 inches long
•
Pin 10:
This is the long blue wire for X button and should be
1.5 inches long
•
Pin 11:
This is the Yellow wire for Y button and should be 2
inches long
•
Pin 12:
This is the Red wire for B button and should be 2
inches long
•
Pin 13:
This is the short blue wire for right trigger and should
be ¾ of an inch long
•
Pin 14:
This is the short white wire which will go to ground
and should be ¾ of an inch long
•
tip: Only strip about 1/8” of the wire for soldering. Exposing
more bare wire could cause a short.
•
tip: For information on proper soldering visit
http://www.curiousinventor.com/guides/How_To_Solder
