Step 8: Solder the left trigger wire.
•
In this step you will need to take the wire from pin 7 and first run it along the bottom of the PCB as
shown in the left image. Use some hot glue to hold the wire in place so that it does not catch on
anything when putting the controller back together.
• Next trim the wire so that you do not have extra wire and strip only 1/8” of the end of the wire.
Then use your soldering iron to attach the wire to the middle of the three trigger pins as show in the
right side image.
Tip: trim you wires so they are only as long as you need, then strip the end and solder into place. Long wires will
just cause a place for something to snag when closing the controller.
Hot glue Here
Solder to
middle of the
3 trigger pins
