8
4. Installation
Fig. 10 Installation tools: folding rule, drilling machine, Phillips-Bit PZ
2 and 3, open spanner sizes 16, 19, 24, hammer, cutter knife, silicone
gun (where required angle grinder with stone cutter)
Fig. 11 Align 2 lower collector fixing clips per collector with batten, fix
with self tapping screws 4 x 35 (max. 100 mm from collector edge and
300 mm from rafter) (1). Insert collectors with approx. 8 mm spacing (2).
Fig. 12 Insert silicone T-profile between collectors. Alternately push-
ing and pulling eases work. Then push collectors together until flush.
Fig. 13 Screw on upper collector fixing clip on both collector edges
with 2 self tapping screws 4 x 35 each, max 100 mm from collector
corner and max. 200 mm from the next rafter.
Fig. 14 Apply thin layer of silicone seal between wings of T-profile
and collector frame.
Fig. 15 Connect collectors. Slide collector connection hoses onto the
collector connections until they lock-in. Check proper fit by pulling
on the hose!