User Manual Rapsody N36
Page
8
Copyright 2008 by Simpex & Ceptra – Alterations and omissions excepted – reproduction & publication is only allowed after obtaining prior permission
3. Set up
3.1. Transmit picture to output device
Make sure that your connected TV, beamer or other display appliance is
ready to receive. Switch your television accordingly to the respective AV
input channel to which the Rapsody is connected.
When you start your Rapsody N36 for the first time, it may send a signal
from the wrong video output channel or it may be necessary to switch over, on the rear, from
PAL to NTSC.
Switch the device on and wait 10 seconds until it is ready.
Now simply press the TV-Out key (lower right) on your remote control and wait a moment each
time your press a key to see if a picture is displayed. Depending on the receiver, it may take a
moment until a picture is displayed. The output mode that is currently active (e.g. DVI) is
displayed on the touch panel front.
If the cable is connected correctly and if the output device is ready to receive, you should have
a picture after switching 5 times, at the most.
You can now proceed to set up the video output.
3.2. Set up
Start the Rapsody. There is a menu item "Setup" in the main menu. You can reach this menu
item either directly with the setup key on your remote control or with the right and left arrow keys
and the OK key. In the setup menu, you also navigate with the arrow keys.
Simply press the setup key when you want to leave the setup menu. Your changes will now be
saved.
