Conrad 64 64 24, Руководство по эксплуатации, Страница: 38 / 104

38
c) Application of several transmitters
On delivery, each transmitter of the FS20 system has a different randomly set
house code.

If you want to control several receivers together via different
transmitters, you first have to attune the house codes of the transmitters
and set the same house code on each transmitter!
This operation has to be performed prior to the initial
programming of the receivers, as the corresponding house code
is also transmitted to the receiver here.
The channels of the transmitters are already set to the same addresses and only
have to be changed if necessary.
d) Timer functions
To program the timer function of a receiver, you have to press its allocated key pair
(e.g. channel 1 for the keys "1" and "2") simultaneously (longer than one second,
but less than 5 seconds!).
Use this command to activate and deactivate the timer programming. For the
actual programming steps, refer to the instructions in the corresponding receiver
manuals.
e) Dual channel number
Besides the standard setting as a 3-channel transmitter, you can also use the
transmitter as a 6-channel transmitter.
Then each channel is only allocated a single key and not a key pair.
Switching between single and dual channel number
As described at the beginning of chapter 9, you have to put the jumper "J1" into the
position "Prog"; otherwise programming is not possible.
The dual channel number is set by simultaneously pressing the keys "2" and "3"
for at least 5 seconds. The LED lights up briefly for confirmation.
The single channel number is set by simultaneously pressing the keys "1" and "4"
for at least 5 seconds. The LED lights up briefly for confirmation.