11
B460IRR40P V1.0 Azden IRR-40P ‒ User & Installation Guide
Channel change
Most users will never need to change the channel of the handheld microphone. If one
Swift
TX
and one handheld mic are being used, there will be no need to change channels.
More than one pendant or handheld microphone transmitter can be used on either channel
for team teaching as long as only one is switched on at any one time.
To use two of the same type of microphone simultaneously,
then one will need to have its channel changed.
The handheld transmitter is normally used on channel B.
However, if required, it can be changed to channel A as follows:
Unscrew the battery cover and the switches will be easy to see
just above the battery compartment.
Use the end of a paperclip or a small screwdriver to slide the
channel switch between channel A and channel B as required.
Please note that the label fitted to the outside of the
battery compartment indicates the switch positions as
‘CH1’ (= Channel A) and ‘CH2’ (= Channel B).
Hi CH2
(B)
Default setting:
The left hand switch should always be left on ‘Hi’.
Right battery ‒ exposed end
This battery is fitted with the
exposed metal end against
the spring and the side
contact.
High capacity rechargeable AA
battery ‒ exposed end
(MBRAAHX1E)
.
Pull out the old batteries. Replace
with two new rechargeable
batteries, taking care to place the
battery with the exposed end in
the side with the spring at the
mic head end
and the contacts
beside the spring. This is
essential for correct charging.
Screw cover back on.
Changing the rechargeable batteries
The rechargeable batteries will only need replacing very occasionally ‒ depending on use.
They will last between 1-2 years.
Side contact
Left battery
High capacity
rechargeable
AA battery
(MBRAAHX4 ‒ pack of 4).
To open the battery compartment, unscrew
the metal sleeve below the switch and slide
the cover off.
Exposed
metal end
Azden IRR-40P Soundfield
