Xtreme/GbE - Managed Carrier Ethernet Switch
Users Guide
Document: CTIM-00429
Revision: 0.11
Page 25 of 31
Date: 2021-01-05
FACTORY DEFAULT CONFIGURATION
The factory default configuration is a VLAN unaware L2 switch with automatic learning/ageing and auto
negotiation enabled on all ports:
•
System: The system name string is empty.
•
Console: The password string is empty and inactivity timeout is disabled. The prompt is “#”.
•
Port: All ports are enabled for auto negotiation and flow control is disabled. Max frame size is
9600.
•
MAC table: The table is empty, auto learning and ageing is enabled. The ageing timer is 300
seconds.
•
VLAN: Only VLAN 1 is present in the table and includes all ports. All ports are VLAN unaware
with Port VLAN ID 1. All ports accept all frame types.
•
User Groups: User group 1 exists and includes all ports.
•
QoS: If supported, IP ToS Precedence priority is enabled and all Precedence values are given high
priority, otherwise port mode is enabled. VLAN tag priorities will be set according to 802.1p. The
UDP/TCP port list is empty. Default priority is high. Default user priority is 0. L4 default priority
and match priority are low. All shaper and policers are disabled.
•
Mirror: Mirroring is disabled.
•
IP: IP mode is enabled and the default IP address is
192.168.42.1
•
IP: DHCP mode is disabled.
•
SNMP: SNMP is enabled. Traps are disabled.
•
Dot1X: 802.1X is disabled. All ports set to “Force Authorized”
HARDWARE USAGE EXAMPLES
Instructions for Standalone Operation
1.
Ensure all external system power supplies are off.
2.
Plug in external power into the external input power connector.
3.
Ensure voltage is in the range of +9V to +36V
4.
Turn on external power supply
5.
XDG will now boot up
6.
Plug in all Ethernet cables to XDG and begin setup operation and use.
Instructions for Installation in PCIe/104 Stack
1.
Ensure all external system power supplies are off.
2.
Plug XDG board onto PCIe/104 stack (top or bottom stacking)
3.
Ensure that the PCIe/104 bus will 12V over the bus connector
4.
Turn on the PCIe/104 system
5.
XDG will now boot up
6.
Plug in all Ethernet cables to XDG and begin setup operation and use.
