Conductix-Wampfler Cluster Bar, Руководство пользователя

Страница: 7 / 16

7
IOM CLUSTER BAR MANUAL 964000.5.0
2.0 Installation
2.5 Anchor Clamps
2.5.1 Check installation drawings for anchor clamp locations. If no
installation drawings for anchor clamp locations, anchor as shown in
Figure 1 on Page 3.
2.5.2 Position one anchor clamp kit on each side of hanger clamp
location. Anchor clamp kit to be mounted alternately on two adjacent
hanger locations (see Figure 11).
2.5.3 Tighten screws to 35 in. lbs., so that they grab cluster bar. Do not
over-tighten.
2.5.4
Note:
Before tightening anchor clamps, verify that expansion gaps
are properly set (see Section 2.6).
2.5.5 On multi-conductor systems, anchor clamps will not fit on adjacent
conductors and so must be staggered (see Figure 9).
Figure 6
.60
#10 AWG
2-3/8”
2”
2-1/4”
3-1/2”
Retainer Cap
Powerfeed Kit
Assembly
Figure 7
Figure 8
19/32”
1”
7/16”
13/16”
1/2”
1-5/8”
#8 AWG or
#10 AWG
2.4 Powerfeed
2.4.1 Locate powerfeed at a joint or end, or install
powerfeed at any point along a straight run by cutting
out 2-1/4” of the conductor cover.
2.4.2 Joint Powerfeed
(See Figures 6 & 7)
2.4.2.2 Attach a wire to terminal supplied with
Powerfeed Kit. Place powerfeed halves and terminal on
conductor bar and fasten supplied hardware.
2.4.2.3 Snap on powerfeed cover halves and press
retainer cap over top.
2.4.3 End Powerfeed (See Figure 8)
2.4.3.1 For powerfeed located on end, cut back
cover 1-5/8” from end of bar. Attach wire to terminal
supplied with kit. Place powerfeed clamp halves
and terminal on conductor and fasten with hardware
supplied. Press on end cover.
2.4.3.2 If necessary, deform legs of conductor outwards
slightly to provide a press fit for plastic end cover.
4 Conductor System
Figure 9
Anchor Clamp
Multi-Conductor
Hanger Clamp