Operation Manual
Regulator
4 kW 560 V DC 40% Duty Cycle + 24 V DC
BAL9100-0126d-EN
www.conductix.com
original document
page 14 of 32
7.4.2
Example: Using the Interface
Below is an example of connection when both the power output and the interface connection are used.
The interface connection allows turning on and off the Regulator even under load and provides as well an easy way to reset the
device in case a fault has been detected. These basic functions are fulfilled by the switch connected between pins 1 and 4 on the
vehicle side. Due to the low voltages involved and the isolated characteristics of the interface connections, the switch requires very
basic isolation and ratings (24 V DC / 150 mA).
Initial status of relays, please see chapter 10.