9
L10 SERIES RADIO CONTROL MANUAL
PN 701L10005.1.5
5.0 Operation (Continued)
5.2.3 Change of Frequency
It is easy to change frequency of the SAGA1-L series simply by replacing
correspondent frequency crystal in both the TX and RX.
Note:
To replace a new crystal, please note that there are two kinds of
frequencies (VHF and UHF) available. The indication of VHF or UHF is
shown on PC board with a check mark “V” and please make sure not to
replace a VHF crystal unit into UHF PC board or vice versa.
5.2.3.1 Instructions
1. Pry up the crystal unit with a flat screwdriver.
2. Remove the crystal unit from the system.
3. Use a needle nose pliers to straighten both pins of the new crystal unit.
4. Insert the new crystal unit vertically into the PC board.
5. Press the new crystal down into the socket.
Attention: The frequency will be different when plugging
the same crystal into the Tx or RX. For example:
T : 311 MHz
R : 321.7 MHz
Frequency for
TX is 311 MHz
Frequency for
RX is 321.7 MHz
1.
2.
3.
4.
5.