5
L10 SERIES RADIO CONTROL MANUAL
PN 701L10005.1.5
2.0 Safety Considerations (continued)
2.2 Warnings
2.2.1 Read this manual carefully before operating and install-
ing this product.
2.2.2 Due to the complex nature of equipment, it is necessary
to read the entire manual before installation.
2.2.3 Only authorized personnel should service this equipment.
Unauthorized work on this unit will void the warranty.
2.2.4 This manual is for reference only; please call your
distributor or Conductix-Wampfler if further assistance is
required.
2.2.5 The equipment has been tested for correct operation before
delivery from the factory. However, it must not be used in critical or
hazardous operation where incorrect operation may cause personal or
equipment damage.
2.2.6 After daily operation, please shut off main power in crane, the
power to the receiver, and remove transmitter key.
2.2.7 Transmitter should be placed in a safe place when not in use to
avoid accidental pressing of buttons.
2.2.8 The crane should be equipped with mainline contactor, limit
switches, and other require safety devices as dictated by CMAA, OSHA,
or all other applicable governing regulations.
2.2.9 The GND (ground) of receiver must be connected to
ground of machine, or electrical shock can occur.
2.2.10 Do not use this device during electrical storms or
under conditions of electrical interference.
2.2.11 Ensure transmitter batteries are in good condition and power for
receiver is correct.
2.2.12 Installation and maintenance should be done only
while the machine’s main power and receiver’s power are off
and locked out to prevent electrical shock.
2.2.13 Contents of the manual may be amended by the
manufacturer without notice.
3.0 Standard Components
3.1 Receiver & Transmitter
3.1.1 A standard and full set of L10 wireless pendant consists of:
700DHHL10
Kits include two (2) transmitters.
NOTE:
Upon receipt of the radio kit, please identify and verify the
following components are included as listed.
3.1.2 Receiver
Receiver Part No.
701L10001
3.1.3 Transmitter
Two Speed Transmitter, Part No.
701L10002