7
L10 SERIES RADIO CONTROL MANUAL
PN 701L10005.1.5
4.0 Installation Procedures (Continued)
4.2.1.1 Modify Power Supply Connection
After the desired power supply is confirmed, disconnect the plug from
the 110V connector, located in the lower left corner of the relay module
board as shown, and insert it into the correct connector on the relay
module. Verify the plug is inserted correctly.
4.2.2 Installation Procedure
1. Turn off the main power for crane or device.
2. Find a proper place for the receiver as detailed in the previous
section.
3. Drill a hole for the 8mm stud, mount the receiver with 8mm diameter
hex nut.
4. Connect wires to the control circuit of crane according to the
receiver’s wiring diagram and control contact diagram.
5. Secure the cables between the receiver and crane so that the cable
sheath will not wear out due to vibration of the crane.
6. Turn on the main power for crane.
7. Complete Section 4.3 and then operate the transmitter
to test every function and make sure all motions are correct
(read by LED indicator).
8. This completes the installation of receiver.
4.3 Transmitter Setup
4.3.1 Place batteries in proper direction into battery compartment,
and screw on transmitter’s bottom cover, after battery installation the
transmitter will sound two (2) 0.5 second long beeps to indicate proper
installation.
NOTE
: For the following procedures the buttons on the transmitter will be
reffered to as noted above.
Button #2
Button #4
Button #6
Button #8
Rotary Key
Emergency
Mushroom
Stop (EMS)
Button #1
Button #3
Button #5
Button #7