CONDTROL 1-2-156, Руководство пользователя

Страница: 7 / 29

12 13
user manual user manual
EN EN
CROSS
LINE LASER
CROSS
LINE LASER
CONDTROL NEO G1-360 CONDTROL NEO G1-360
5. Turn the instrument by 180 ° and mark the point where laser lines
intersect each other on the opposite wall as A2 (A1, A2 must be on the
same vertical line) (see figure D).
D
6. Measure distance dA between points A1 and A2 and dB between
points B1 and B2 (see Figure D). If deviation between dA and dB values
exceeds 3 mm, please contact the service center.
CHECK OF VERTICAL LINE
Use a plumb bob as a reference of a vertical line. Place the instrument
at distance of 1,5m from the plumb bob.
1. Unlock the compensator, switch on the vertical laser line and align it
with the low point of plumb bob.
2. If deviation between the laser line and the plumb bob line exceeds
±0.3 mm per 1m of the plumb bob length (for a 2.5m plumb bob
deviation shouldn’t exceed 0.75 mm) please contact service center.