Condair Nortec GSTC, Инструкция по установке и эксплуатации

Страница: 13 / 60

8 | Links XPS Nortec GSTC/ SETC B+
Wiring
BACnet MS/TP, Johnson N2, and LonWorks
Links XPS is pre-installed and factory wired, except for the Nortec SETC-050 which is provided in
its own separate enclosure. Connections must be made between the master humidifier and the
Building Management System (BMS), and the master humidifier and any slaves that may be
present.
Up to 8 units (1 master, 7 slaves) may be connected to a BMS through a single gateway in the
master unit. The units are daisy chained via the Links XPS terminal strip. The wire shield
should only be connected at one end per pair of units when “daisy chaining”. Older A and B
style units use a different connection method, please refer to revision C of this manual.
Table 2 refers to the recommended wire types and maximum recommended lengths from the
Links XPS module to the front-end of the Building Management System. Since communication
between the humidifiers and Links XPS occurs via an EIA-485 signal type, Condair recommends
using an 18-24 AWG shielded, 120

twisted pair wire between the lead humidifier and each of
the slave humidifiers. Total cable length runs between the Links XPS module and the furthest
slave humidifier should not exceed 2,000 feet. Signal boosters or repeaters may be necessary
for longer wire runs or where electrical noise interference is prevalent.
Table 2: Recommended Wire Types and Lengths
Protocol Signal Type
Polarity
Recommended Cable
Maximum Recommended
Distance from Module
A B
BACnet MS/TP
EIA-485,
2-wire
Net + Net -
18-24 AWG
Shielded, Twisted Pair
2000 ft at 9,600 bps
2000 ft at 38,400 kbps
Johnson N2
BACnet/IP LAN standard N/A N/A
CAT.5E cable with RJ-45
termination
Depends on cable
manufacturer
LonWorks
FTT-10,
2-wire
Tx Rx
18-24 AWG
Twisted Pair
Should not exceed 50 ft.