Concept2 VP 8310, Руководство пользователя

Страница: 36 / 64

29 VP9181
EN
CLEANING AND REPLACING THE AIR OUTLET FILTER
1. Open the air outlet grid in the appliance‘s rear section (Fig. 5).
2. Remove the air outlet filter. This type of vacuum cleaner is equipped with a
H.E.P.A. filter in the outlet, which is capable of catching even very fine dust
particles. You can clean this filter by tapping it, then brushing it with a soft
brush. After this operation is complete, you may clean a very dirty filter by
washing and brushing with a soft brush in lukewarm water with no cleaning
agents added. It is important to let the wet parts dry thoroughly. A wet filter
will be damaged by vacuuming! Do not use a hair dryer to dry it!
Note:
Wet cleaning may cause more wear and tear of the filter and,
consequently, may shorten its service life.
3. Insert the cleaned or new air outlet filter into the appliance and close the air
outlet grid.
TROUBLESHOOTING
Problem Cause Solution
Motor does not run.
Plug inserted into the mains outlet
incorrectly or insufficiently.
Check the plug connection.
The mains outlet is not live.
Check for voltage, e.g. by connecting
another appliance.
Motor has stopped
operating. Improper or insufficient air flow. Motor
overheating fuse activated.
Disconnect the cable from the socket.
Check and release the air suction
and discharge holes; check the filter’s
cleanliness and/or replace the dust bag.
Let the vacuum cleaner cool down.
Front cover cannot be
closed
Dust bag inserted incorrectly. Check the dust filter installation.
Reduced suction power
Dust bag full or clogged. Replace the dust bag.
Obstructed filter. Clean or replace the filter.
Clogged nozzle, tube, or hose.
Check and clear the air passage on the
suction and discharge sides.
Vacuum cleaner heats
up
Slight heating of the vacuum cleaner is normal and cannot be considered a failure.
OPTIONAL ACCESSORIES
The following appliance accessories can be purchased additionally:
SMS dust bags (5 units + 2 units of motor filters) Order code sms9000
Priced according to the valid price list
Fabric dust bag, 1 Ord. No. ts9180 Price according to the applicable price list
Motor filter Order code44290910 Price according to the valid price list
H.E.P.A. air outlet filter Order code 44290911 Priced according to the valid price list
(Fig. 5)
29 VP8110, VP8111, VP8112
EN
(Fig. 5)
CLEANING AND REPLACING THE AIR OUTLET FILTER
1. Open the air outlet grid in the appliance‘s rear section (Fig. 5).
2. Remove the air outlet filter. You can clean this filter by tapping it, then brushing it
with a soft brush. After this operation is complete, you may clean a very dirty filter by
washing and brushing with a soft brush in lukewarm water with no cleaning agents
added. It is important to let the wet parts dry thoroughly. A wet filter will be dam-
aged by vacuuming! Do not use a hair dryer to dry it!
Note: Wet cleaning may cause more wear and tear of the filter and, consequently,
may shorten its service life.
3. Insert the cleaned or new air outlet filter into the appliance and close the air outlet
grid.
OPTIONAL ACCESSORIES
The following appliance accessories can be purchased additionally:
SMS dust bags (5 units + 2 units of motor filters)
Order code sms9000 Priced according to the valid price list
Fabric dust bag, 1 Order code 44291711 Price according to the applicable price list
Motor filer Order code 44291704 Price according to the valid price list
28 VP9181
EN
CHECKING THE DUST COLLECTION BAG FILL
When the dust collection bag fill indicator turns red during operation, replace the full dust collection bag immediately.
If the dust collection bag fill indicator is still red after the bag has been replaced, this may be due to several causes:
- some of the air passages (hoses, telescopic tube, suction inlet, brush adapter, or other adapters) are obstructed;
- the motor filter is dirty;
- the air outlet filter is dirty.
Check for each of the possible causes above and eliminate the problem before you start vacuuming. If the cause of the
problem cannot be identified, hand over the product to the nearest service centre. Never use the vacuum cleaner if the
bag level indicator is completely red during operation. The motor could be damaged irreparably
CLEANING AND MAINTENANCE
You may clean the accessories and the appliance with a wet cloth. Never immerse
the appliance in water! Do not use any aggressive substances for cleaning, such as
solvents or abrasives!
REPLACING THE DUST COLLECTION BAG
1. Unplug the product from the mains. Disconnect the hose from the suction inlet
and open the appliance cover.
2. Push the flap on the dust retention bag holder; remove the used dust retention
bag (Fig. 3). Dispose of a paper or SMS dust collection bag. Be careful not to tear
the bag when handling.
If the bag is made of fabric, empty it and close it
carefully - it can be used repeatedly.
3. Insert a new or empty dust retention bag by fitting the plate in the bag holder. The
bag opening must be aligned with the hose hole in the appliance cover.
4. Never use the vacuum cleaner without the dust bag installed! If you forget to
insert the dust retention bag or you insert it incorrectly, the appliance‘s motor
may become damaged.
5. Close the cover. Press until you hear a click.
REPLACING FILTERS
• The filters should be cleaned or replaced when they are visibly dirty, or if the
appliance‘s suction power is reduced. Always check the filters after using the
appliance.
• In order to avoid damage to the appliance, do not use it with incorrectly installed
filters.
• Before replacing the filters, disconnect the appliance from the electrical socket.
• You can buy suitable types of filters from your dealer, or you can order them from
the manufacturer.
CLEANING AND REPLACEMENT OF THE MOTOR FILTER
1. Disconnect the flexible hose and open the appliance cover.
2. Pull the dust collection bag out of its holder so that you can access the motor filter
more easily.
3. Remove the motor filter (Fig. 4). You can clean the filter by tapping it. If the filter is
heavily soiled, you may wash it in lukewarm water and let it dry properly.
4. Insert the cleaned or new motor filter into the appliance and close the cover.
(Fig. 3)
(Fig. 4)
28 VP8110, VP8111, VP8112
EN
(Fig. 3)
(Fig. 4)
EN
36 VP 8310