Concept2 Titanium TI100, Инструкция по установке и эксплуатации

Страница: 6 / 30

Page 6 of 30
1.3 INTRODUCTION
This manual covers the Titanium line of products
Before commencing installation of the Smoke Screen ensure that you have all of the following
equipment supplied in the box:
•
1 x Smoke Screen
•
1 x Mounting Bracket
•
1 x Swift-fit fluid reservoir
•
2 x 12v Batteries.
•
1 x Literature Pack & Warning Sign
You will also require:
•
Mains power supply and connections into the Alarm Panel or other triggering system.
•
PIR (or equivalent) to provide the hold-off where required.
•
Optionally a Screen Sensor for top-up functionality
1.4 OVERVIEW
The Smoke Screen is designed to form part of an existing intruder alarm system but may also be
configured as a ‘stand-alone’ system or as part of a centrally monitored, command and control system.
A typical
installation is shown in the following schematic:
1.5 TYPICAL INSTALLATION
A typical installation can be configured in the following way:
•
The Smoke Screen is wall or ceiling mounted in the appropriate location.
•
A Hold-off PIR (or similar device) located within the same area as the Smoke Screen providing
a confirmation signal to the Smoke Screen to start, or re-start, ‘smoke’ production.
•
A Set command supplied by an Alarm Control Panel, or equivalent, in the form of an N/C
(Normally closed) or an N/O (Normally open) relay changing state when the Alarm system is
set for operation.
Smoke Screen
Alarm Panel
IP status outputs
IP command inputs
Alarm Hold-off (PIR or
similar device)
Smoke Screen
User Interface
(Optional)
Status
Test Facility
Status outputs
Activation commands
Activation commands
for test facility